Go Down

Topic: M42SP-6TE stepper motor interfacing (Read 6531 times) previous topic - next topic


This is a 4-wire bipolar stepper motor. In the motor connector the first coil is wires 1 and 2, the second coil wires 3 and 4. Coils have 10 Ohms resistance.

The four pin arrangement with H-Bridge should work. (No H-bride available now to test, but with two wires it jump back and forth - will repost if H-bridge fails).

Schematic: http://arduino.cc/en/Reference/StepperBipolarCircuit.
Test code: Use the Arduino IDE built-in one rotation test code.
Graphical explanation of stepper motor operation: http://www.imagesco.com/articles/picstepper/02.html

Reson for his post: couldn't comment on the old forum post and no easily available info on this steppermotor.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131