Go Down

Topic: Run I2C device with other sensors (Read 318 times) previous topic - next topic

otter

Hello
I'm looking at running a mpu6050 device along with a ultrasonic sensor and xbee on my UNO. Before I begin coding, I realize that I2C devices can tie up the serial monitor on an arduino. This being, I can pull data off the mpu6050, but if I add any other sensors to the UNO the mpu6050 data will get bogged down and unusable. Is there a way to get past this where all can run somewhat in harmony?

wvmarle

Before I begin coding, I realize that I2C devices can tie up the serial monitor on an arduino.
Why do you think it's like this?

I'm having no problems connecting several I2C and a few other sensors to a single processor (an ESP8266 in my case) and get information on the serial monitor at the same time.
Quality of answers is related to the quality of questions. Good questions will get good answers. Useless answers are a sign of a poor question.

Go Up