Pages: [1]   Go Down
Author Topic: Bluetooth serial trouble - RN-42  (Read 1552 times)
0 Members and 1 Guest are viewing this topic.
London
Offline Offline
Full Member
***
Karma: 0
Posts: 192
Yes, we can (solder)!
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi,


I've been trying to connect my Duemilanove to an RN-42 Bluetooth modem(TX to RX, RX to TX). The modem connects perfectly, even enters command mode when prompted. The sketch I wrote sends data to the serial port. However there's nothing going through the BT modem. I cannot even see the TX/RX leds blinking (the same sketch works perfectly with USB). I also added a voltage divider to the TX of the Arduino to bring the voltage down from 5 volts. It seems that the board can't see the BT modem as a serial port. Do I need to define TX and RX as serial port in the sketch? Any help would be great!

This the sketch:

int val=0;
long randomvalue = 0;

void setup(){
  Serial.begin(9600);
 }
void loop(){
   Serial. write(val);
   randomvalue = random(1000);
   Serial.println(randomvalue);
   delay(2000);
}
Logged

Pages: [1]   Go Up
Jump to: