Pages: [1]   Go Down
Author Topic: 6v pwm?  (Read 807 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 44
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hallo
How can I get a pwm output that is 6Volts instead of 5V?

Harry
Logged

nr Bundaberg, Australia
Offline Offline
Tesla Member
***
Karma: 121
Posts: 8439
Scattered showers my arse -- Noah, 2348BC.
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Run the PWM Arduino pin through a resistor to a transistor with the collector tied to 6v and emitter to GND.

Tap your 6v signal from the collector.

Note that this will invert the signal so 0 will == 255 and vv.

______
Rob
Logged

Rob Gray aka the GRAYnomad www.robgray.com

0
Offline Offline
Newbie
*
Karma: 0
Posts: 44
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Thank you very much Rob
Logged

Pages: [1]   Go Up
Jump to: