Go Down

Topic: 6v pwm? (Read 984 times) previous topic - next topic

harrys

Hallo
How can I get a pwm output that is 6Volts instead of 5V?

Harry

Graynomad

Run the PWM Arduino pin through a resistor to a transistor with the collector tied to 6v and emitter to GND.

Tap your 6v signal from the collector.

Note that this will invert the signal so 0 will == 255 and vv.

______
Rob
Rob Gray aka the GRAYnomad www.robgray.com

harrys

Thank you very much Rob

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy