Go Down

Topic: High Power RGB LED Shield (Read 13958 times) previous topic - next topic

I'm trying to work out why the error amplifier compensation pin (VC) resistors (R5, R6 and R10) different from the reference design on the data sheet for the LT3496. On your design they are set to 0ohm. Should they not be 10k or 22k?

P.S.
Sorry for replying to an old thread.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy