Pages: [1]   Go Down
Author Topic: Burn Sketch option in IDE  (Read 1311 times)
0 Members and 1 Guest are viewing this topic.
United Kingdom
Offline Offline
Tesla Member
***
Karma: 223
Posts: 6593
Hofstadter's Law: It always takes longer than you expect, even when you take into account Hofstadter's Law.
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

I would like a command to burn a sketch directly to hardware. It would allow the ISP to be selected (just like the Burn Bootloader command), program the sketch into the target processor, and set the fuses. Currently, to do this I have to temporarily modify the "upload.using" line, upload the sketch, then run avrdude from a command line to set the fuses.
Logged

Formal verification of safety-critical software, software development, and electronic design and prototyping. See http://www.eschertech.com. Please do not ask for unpaid help via PM, use the forum.

Pages: [1]   Go Up
Jump to: