Go Down

Topic: 6 Wire Stepper motor, NMB-MAT PM42S-048 (Read 7868 times) previous topic - next topic


I am having a 6 wired stepper motor, NMB-MAT PM42S-048 which i am trying to connect to Arduino. I searched for data sheets but wasn't able to find any related help. All i got was the 4 wire having different wire color code details. I am confused and not able to understand how i can control it.
CAn you please guide me, how can i do it so?



The only law for me; Ohms Law: U=R*I       P=U*I
Note to self: "Damn! Why don't you just fix it!!!"


The link is broken.

That sounds like a unipolar stepper motor. It has two center-tapped phases. You connect the center taps to a power source and then switch the the ends of the coils to ground in sequence in order to turn the motor. See http://www.cs.uiowa.edu/~jones/step/ for Doug Jones's exhaustive stepper motor tutorial.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131