Go Down

Topic: Interfacing with Flash CS4 (Read 954 times) previous topic - next topic

CodeBlue

I'm attempting to interface my Arduino with Flash, but I'm running into some problems. I run Serproxy, but when I try to run the flash file the Dos window for Serproxy outputs..

Code: [Select]
Server thread launched
server(4) - thread started
Failed to open comm port - connection refused

I'm not sure what the problem is. In the arduino IDE I use com4 to program so I figure that its the same. Below is the also the config file for Serproxy..

Hope I can get some help on this,
Thanks

Code: [Select]
# Config file for serproxy
# See serproxy's README file for documentation

# Transform newlines coming from the serial port into nils
# true (e.g. if using Flash) or false
newlines_to_nils=true

# Comm ports used
comm_ports=1,2,3,4,5,6

# Default settings
comm_baud4=57600
comm_databits4=8
comm_stopbits4=1
comm_parity4=none

# Idle time out in seconds
timeout=300

# Port 1 settings (ttyS0)
net_port1=5331

# Port 2 settings (ttyS1)
net_port2=5332

# Port 3 settings (ttyS2)
net_port3=5333

# Port 4 settings (ttyS3)
net_port4=5334

# Port 5 settings (ttyS4)
net_port5=5335

# Port 6 settings (ttyS5)
net_port6=5336



Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy