Go Down

Topic: help me . new to arduino!!!!! (Read 2449 times) previous topic - next topic


Feb 15, 2011, 12:33 pm Last Edit: Feb 15, 2011, 12:44 pm by sohaib Reason: 1
hello all. i am new to arduino.as it is not avalible in my country so i decided to built by myself.i have started building single sided arduino (http://arduino.cc/en/Main/ArduinoBoardSerialSingleSided3).
can i use ATmega32 instead of ATmega8?
also is there any simple diy programmer to burn a bootloder in ATmega32?thanks in advance.


Rob Tillaart

Nederlandse sectie - http://arduino.cc/forum/index.php/board,77.0.html -
(Please do not PM for private consultancy)


Hi @sohaib, no the documents of Serial Single Sided V3 clearly states that you can only use ATMEGA8 or 168 because these both are pin compatible. I don't read the docs for ATMEGA32 but i think its not pin compatible with the board.
You can use the Parallel Programmer (dapa) http://www.arduino.cc/en/Hacking/ParallelProgrammer i hope it will work for you.
I wish you good luck because it have been almost a month that i m still trying to do the same thing.


Feb 15, 2011, 02:45 pm Last Edit: Feb 15, 2011, 02:50 pm by hexskrew Reason: 1
Actually yes they are both pin compatible.


Fuses are different I believe though, but you just program it with the correct bits and your golden.

OHH!! Atmega32? No. It's definitely not pin compatible. The Atmega32 is 40 pins. I am working on that chip now, and it's not supported in the arduino ide either at this time. You would do better with the atmega 8 128 or 328 for now till your more comfortable with the way it works.


You can checkout this tutorial video..I hope this helps you..


Good luck!!

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131