Pages: [1]   Go Down
Author Topic: Arduino BT and ITG3200 Gyro  (Read 1202 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 30
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Im using the following sourcecode
http://rfid-synergie.de/itg3200.html.txt
on my arduino BT atmega 328.
I get Datas but I think the datas are not exact. It seems like the sensor is more sensitive compared to a very similiar sourcecode which I m using on my arduino dumilanove.It only takes a short move of the sensor and the Z axis of the gyro shows a full scale of 2000 degrees per sec. I power the board with two 1,5 V batteries.
thx greets Kris
« Last Edit: February 22, 2011, 07:06:54 pm by kris2010 » Logged

0
Offline Offline
Newbie
*
Karma: 0
Posts: 30
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

The full skale range of each of the axis (I turned) were reached after a short moment .
Logged

Pages: [1]   Go Up
Jump to: