Go Down

Topic: current rating for this plug (Read 956 times) previous topic - next topic


I am trying to figure out a nice jack to put on my enclosure.  Does anyone know if this 9 pin D-subminiature Female jack would handle 1 amp?

I can't find any specs on these, as I reckon they're not made for this type of thing.  I need to power a solenoid for just a minute or so.


DB-9 connectors are designed for signals rather then power, however I think 1 amp current is well within it's capabilities.



They are not meant for this kind of thing, but they are used for this kind of thing all the time.

Since you have 9 pins, put a bunch of pins in parallel (4 for each solenoid wire) and you should be quite OK since they will share the current.

Unless, of course, someone thinks that this connector is a serial port and tries to connect it to a PC using a serial cable. Then there will be surprises.

The Aussie Shield: breakout all 28 pins to quick-connect terminals


Looks is my primary goal here.  So the aussie shield won't do.  I want my enclosure (picture attatched) to have nice panel mount jacks for my gearmotor, a solenoid, and a flowsensor.
The soenoid (watervalve) and flowsensor are right next to each other, so one cable going that direction (3' cable is about the distance I'll have)  The flow sensor uses V+, Gnd, and Signal; the Solenoid uses V+, and Gnd, so a 4 conductor would work, a 5 conductor would be ideal.  I could do them all in 1/8" headset jacks, which handle 1 amp I believe.
...still looking for a visually pleasing panel mount jacks.


DB9 is not ideal but would work. You can get them with IDC connections so you don't have to solder 9 wires.

They are a pain to make the hole though.

What about DIN connectors, they come in many pin numbers, lock in, and don't have a weird shape so holes are easy.

Rob Gray aka the GRAYnomad www.robgray.com

Go Up