Go Down

Topic: Arduino BT and ITG3200 Gyro (Read 1 time) previous topic - next topic

kris2010

Feb 22, 2011, 11:58 pm Last Edit: Feb 23, 2011, 01:06 am by kris2010 Reason: 1
Im using the following sourcecode
http://rfid-synergie.de/itg3200.html.txt
on my arduino BT atmega 328.
I get Datas but I think the datas are not exact. It seems like the sensor is more sensitive compared to a very similiar sourcecode which I m using on my arduino dumilanove.It only takes a short move of the sensor and the Z axis of the gyro shows a full scale of 2000 degrees per sec. I power the board with two 1,5 V batteries.
thx greets Kris

kris2010

The full skale range of each of the axis (I turned) were reached after a short moment .

Go Up