Go Down

Topic: Arduino without ftdi chip. (Read 3 times) previous topic - next topic

Tom

Hi all.
Does anyone tried atmgea chips with USB supported communication?
Like this "ATmega32U4-AU",
Is it possible leave ftdi chip and use internal cicruit for usb programming?

orbitalair

Yes.  teensy is one.  http://www.pjrc.com/teensy/
It comes in 2 flavors.
Its ok, and it does work, but you use a different library so you have to be very careful if you want code that works on both usb and nonusb arduinos.

Another approach, if limited usb support is all you need, is to use software usb like vusb.
http://www.obdev.at/products/vusb/index.html
This approach will use about 1.5kb of your program space.


frank26080115

#2
Mar 02, 2011, 03:44 pm Last Edit: Mar 02, 2011, 05:40 pm by frank26080115 Reason: 1
V-USB is awesome, check out USnooBie, its bootloader does not require any sort of serial converter at all.
Freelance engineer, consultant, contractor. Graduated from UW in 2013.


Tom

Thanks for replies. But if i understood well I don't need hardware support of USB as i mentoined.
I can use V-USB in every (almost) atmega chip.
I was thinking about using that dedicated USB pins. I would like to know more about that.

Go Up