Pages: [1]   Go Down
Author Topic: RBBB and UNO  (Read 1115 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

If I have an UNO, can I use a RBBB (with the ATmega328 ) and swap chips with the UNO to program the chip from the RBB?  There's a difference in the bootloader (RBBB has the Diecimila bootloader) on it but I'm not sure what that really means in terms of doing it.
Logged

Global Moderator
Dallas
Online Online
Shannon Member
*****
Karma: 211
Posts: 13044
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset


I would be very surprised if you had problems after swapping the processors.

You will need to select the board based on the the bootloader ... Select Diecimila when using the Uno with the RBBB processor.

Or, if you don't want to remember which processor is installed in the Uno, you could burn the same bootloader on both processors.
Logged

Central MN, USA
Offline Offline
Tesla Member
***
Karma: 75
Posts: 7272
Phi_prompt, phi_interfaces, phi-2 shields, phi-panels
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

If you decide to do that, you're suggested to bootload the diecimila with the latest UNO bootloader.
Logged


Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I think I'll try burning the UNO bootloader to it.   Thanks
Logged

Pages: [1]   Go Up
Jump to: