Go Down

Topic: updating the DFU bootloader on ATMega8U2 of Arduino UNO (Read 3191 times) previous topic - next topic


Hi Everyone,

I am trying to reload the DFU bootloader in the ATMega8U2 of the Arduino UNO.
I took the DFU bootloader source code from the D:\arduino-0022\hardware\arduino\firmwares\arduino-usbdfu and placed it in LUFA 100807 project's directory and used WINAVR's programmer's notepad (pn) to generate the .hex file for the DFU bootloader.

I used the commands:
make clean
make all
make program

I kept the Arduino UNO in DFU mode before generating the hex file.
when the 'pn' runs the command make program it is giving the following error:

avrdude: usbdev_open(): did not find any USB device "usb"

Do I need to install any USB drivers to make the Arduino UNO in DFU mode to look like a USB device?
If so, where can I find the drivers?
Am I following the right method to reload the DFU bootloader? I followed the readme.txt in the arduino-usbdfu directory.

Best Regards,
Anil Palaparthi.


Same problem man.
I am using Flip , and the moment I enabled the DFU mode , The windows started to look for drivers and then message appeared "can't install drivers " 


If you are using Windows , and Atmel Flip for DFU bootloader programing, then the drivers are located at  : (where ever you installed Flip )\flip 3.4.2\ usb 

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131