Pages: [1]   Go Down
Author Topic: Pull 3.3V from Pro Mini regulator?  (Read 704 times)
0 Members and 1 Guest are viewing this topic.
Arduinoville
Offline Offline
Newbie
*
Karma: 1
Posts: 26
Arduino is my strong friend
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

I'm wondering if I power the Arduino Pro Mini 3.3V with a raw voltage (9V, say) can the regulator power the Arduino and allow me to draw current to power an SD card socket from the Vcc pin? An SD card needs 50-100 mA at 3.3V. Anyone tried it?
Logged

Sometimes things are as they appear

Left Coast, CA (USA)
Offline Offline
Brattain Member
*****
Karma: 361
Posts: 17259
Measurement changes behavior
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I think you would be OK. I believe the regulator limit is 150ma so if don't have too much other loads it should work fine.

Lefty
Logged

Pages: [1]   Go Up
Jump to: