Go Down

Topic: Interfacing DOGM128 LCD with arduino mega (Read 1 time) previous topic - next topic


I have just wired up an EA DOGL128 LCD to my arduino mega. I am trying to use the dogm128 library that is compatible with the arduino environment. The only problem is that the library is mainly for the UNO ans the duemilanove. I was wondering if anyone has any experience with the library and if possible help me port it over to the arduino mega.

I have changed a few lines in Dogm/utility/dogm128.h
-Uncommented #define DOGM128_HW
-#define PIN_SCK   52
-#define PIN_MISO  50  //Aparently not used
-#define PIN_MOSI  51
-#define PIN_SS    53
-#define PIN_A0_DEFAULT     22

But I still have nothing on the display after I upload. I'm using a max3002 to convert voltages from 5v to 3.3V.


LCD: http://www.lcd-module.com/eng/pdf/grafik/dogl128-6e.pdf
Connections: http://code.google.com/p/dogm128/wiki/dogm128_arduino_hardware
Installation: http://code.google.com/p/dogm128/wiki/install


Everything works fine I retyped these lines in this post mine were backwards in the header file:

-#define PIN_MISO  50  //Aparently not used
-#define PIN_MOSI  51


Header file seems ok.
Did you solve your problem?


Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131