Go Down

Topic: arduino configure xbee module (Read 974 times) previous topic - next topic


i'm trying to configure an xbee series 2 module under mac.
I have an arduino uno and I'd like to use it to configure the module, so I set the jumper on xbee shield on USB position (both of them), I removed the atmega from arduino, download coolterm, connected arduino with xbee shield and xbee module to usb port.
I lunched coolterm (anebled local echo option) and I can connect via serial port to the board but when i digit (I waited 2sec before digit)
i dont get any OK message (I did not typed "return" botton). Any hint?

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131