Pages: [1]   Go Down
Author Topic: arduino configure xbee module  (Read 496 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Full Member
***
Karma: 0
Posts: 149
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi,
i'm trying to configure an xbee series 2 module under mac.
I have an arduino uno and I'd like to use it to configure the module, so I set the jumper on xbee shield on USB position (both of them), I removed the atmega from arduino, download coolterm, connected arduino with xbee shield and xbee module to usb port.
I lunched coolterm (anebled local echo option) and I can connect via serial port to the board but when i digit (I waited 2sec before digit)
+++
i dont get any OK message (I did not typed "return" botton). Any hint?
Logged

Pages: [1]   Go Up
Jump to: