Pages: [1]   Go Down
Author Topic: Lily Pad w/2 capacitive touch sensors  (Read 2654 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I'm running into some programing issues.

I'm trying to run 2 sets of 12v LEDs through a Lily Pad. Each set of LEDs will have a AD7746 Breakout controlling them. One AD7746 will turn on/off, the other will start at low/med/high output.

Power will come from the wall and I have a step down going to the Lily Pad and a step up going out to the LEDs.

The closest code I've found is this minus a couple tweaks.

I can't decipher what code needs to be "swapped out" for the touch sensors.

Any help would be greatly appreciated. 


Offline Offline
Shannon Member
Karma: 214
Posts: 12434
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

What code?  That site just has a v. simple example AFAICT.   Give us more detail on the circuit if you can

[ I won't respond to messages, use the forum please ]

Pages: [1]   Go Up
Jump to: