Go Down

Topic: "Bluetooth 4.0 iBeacon BLE module" AT Command error 102 in serial monitor (Read 202 times) previous topic - next topic

KSTC

I'm using iBeacon BLE module. I check status and change name is "OK" but i cann't change password or pin. Error message "102".

ieee488

I'm using iBeacon BLE module. I check status and name is "OK" but i cann't change password or pin. Error message "102".
How are we suppose to know?

Get the manual and research what error 102 means!



.

SUPERETDUPER

Have you found the solution I'm getting the same with the HM-10 (specs say nothing)

MartynC

The HM-10 uses AT+NAME[P1] where P1 (no brackets) is the new name. If this is not working you may not have a HM-10.

Go Up