Go Down

Topic: Engineering Drawings (Read 444 times) previous topic - next topic

kinglewuk

Hi, does anyone know if there are any dimensioned engineering drawings of the Due board and plastic mount? I would like to get accurate measurements for a plate I'm making to hold the Due in place and I'm really struggling to find any information.

I know I could use a set of vernier calipers take the measurements myself but I'd rather have the drawings which should be much more accurate.

Delta_G

which should be much more accurate.
Cause if you want a job done right, get the results from where someone else did it. 

Wait, that's not right...


Have you tried here?  I see several options to get the info you're after. 
|| | ||| | || | ||  ~Woodstock

Please do not PM with technical questions or comments.  Keep Arduino stuff out on the boards where it belongs.

Go Up