Pages: [1]   Go Down
Author Topic: Problem Uploading to Board  (Read 543 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Every time i try to upload a program through arduino to my mini using my FTDI i get the same error message,

avrdude: stk500_getsync() : not in sync resp=0x00
avrdude: stk500_disable() : protocol errod, expect=0x14, resp=0x51

Ive tried uploading using the ISP Bootloader, and i still get the same message, any suggestions?
Logged

Espoo, Finland
Offline Offline
God Member
*****
Karma: 7
Posts: 586
"Oops, try again..."
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

This is common problem. What pins are connected between them?

Kari
Logged


The only law for me; Ohms Law: U=R*I       P=U*I
Note to self: "Damn! Why don't you just fix it!!!"

Espoo, Finland
Offline Offline
God Member
*****
Karma: 7
Posts: 586
"Oops, try again..."
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

One more thing, COM-port is correct?

Kari
Logged


The only law for me; Ohms Law: U=R*I       P=U*I
Note to self: "Damn! Why don't you just fix it!!!"

Western New York, USA
Offline Offline
Faraday Member
**
Karma: 39
Posts: 4383
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
Every time i try to upload a program through arduino to my mini using my FTDI i get the same error message,...
Have you looked through the "Installation & Troubleshooting" section of the forum (where this post belongs)?

Quote
Ive tried uploading using the ISP Bootloader
There is no such thing - the two techniques are mutually exclusive.

Don
« Last Edit: March 14, 2011, 08:21:22 pm by floresta » Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

For some reason when i plug into the computer, it gives me the option of com port 12 or comport 13, ive follows the instructions to upload using the avrisp v2 and im still getting the same error message
Logged

Pages: [1]   Go Up
Jump to: