Go Down

Topic: Problem Uploading to Board (Read 585 times) previous topic - next topic

MaltCPE

Every time i try to upload a program through arduino to my mini using my FTDI i get the same error message,

avrdude: stk500_getsync() : not in sync resp=0x00
avrdude: stk500_disable() : protocol errod, expect=0x14, resp=0x51

Ive tried uploading using the ISP Bootloader, and i still get the same message, any suggestions?

GaryP

This is common problem. What pins are connected between them?

Kari
The only law for me; Ohms Law: U=R*I       P=U*I
Note to self: "Damn! Why don't you just fix it!!!"

GaryP

One more thing, COM-port is correct?

Kari
The only law for me; Ohms Law: U=R*I       P=U*I
Note to self: "Damn! Why don't you just fix it!!!"

floresta

#3
Mar 15, 2011, 02:18 am Last Edit: Mar 15, 2011, 02:21 am by floresta Reason: 1
Quote
Every time i try to upload a program through arduino to my mini using my FTDI i get the same error message,...
Have you looked through the "Installation & Troubleshooting" section of the forum (where this post belongs)?

Quote
Ive tried uploading using the ISP Bootloader
There is no such thing - the two techniques are mutually exclusive.

Don

MaltCPE

For some reason when i plug into the computer, it gives me the option of com port 12 or comport 13, ive follows the instructions to upload using the avrisp v2 and im still getting the same error message

Go Up