Go Down

Topic: bma180 accelerometer (Read 5708 times) previous topic - next topic

scjurgen


Ok so I got the scanner working right, however it does not find any addresses.

I re-loaded the sketch for the bma and now it shows the status and control reg along with t=[0 0 0]

0 0 0 is consistent with not communicating to the chip.

Maybe try to snap a picture of your setup and post it here?
Juergen

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy