Go Down

Topic: bma180 accelerometer (Read 6487 times) previous topic - next topic


Ok so I got the scanner working right, however it does not find any addresses.

I re-loaded the sketch for the bma and now it shows the status and control reg along with t=[0 0 0]

0 0 0 is consistent with not communicating to the chip.

Maybe try to snap a picture of your setup and post it here?

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131