Go Down

Topic: Trouble uploading sketch to Arduino UNO (Read 70 times) previous topic - next topic

sahayajensy

I am new to Arduino and I am having difficulty while trying to upload sketch to my Arduino UNO board.  I get the following errors.



avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x83

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x83

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x83

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x83

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x83

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x83

Problem uploading to board.  See http://www.arduino.cc/en/Guide/Troubleshooting#upload for suggestions.

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x83

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x83

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x83

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x83


Kindly guide me..
Thank you

sterretje

#1
Jun 18, 2018, 03:40 pm Last Edit: Jun 18, 2018, 03:41 pm by sterretje
Some things to check.
1)
Is the board recognised by device manager (or its Linux/Mac counterparts)?
2)
Did you select the correct com port in the IDE?
If you understand an example, use it.
If you don't understand an example, don't use it.

Electronics engineer by trade, software engineer by profession. Trying to get back into electronics after 15 years absence.

Go Up