Go Down

Topic: Thermoking coldroom controller and iot (Read 331 times) previous topic - next topic

heinburgh

Hello forum,

I'm running a thermoking coldroom that uses a uP-D controller. I think it's time to get this coldroom online so I can see what's going on and switch it remotely through the net.

First thought was to buy all the temp and pressure sensors and put them in place where all the existing sensors are, but if I could piggy back off the existing system sensors and use the signals as is it would make for a much more streamlined project.

Has anyone here played with this? Any idea what voltage these sensors run at?

Thanks,
Hein

Go Up