Pages: 1 2 [3]   Go Down
Author Topic: bma180 accelerometer  (Read 4702 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Full Member
Karma: 3
Posts: 142
jayduino rox
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Ok so I got the scanner working right, however it does not find any addresses.

I re-loaded the sketch for the bma and now it shows the status and control reg along with t=[0 0 0]
0 0 0 is consistent with not communicating to the chip.

Maybe try to snap a picture of your setup and post it here?


Pages: 1 2 [3]   Go Up
Jump to: