Go Down

Topic: capacitive sensor - work with LEDS (Read 2158 times) previous topic - next topic

I have a capacitive sensor from sparkfun
http://www.sparkfun.com/products/7918

i'd like to connect this to an arduino uno and have it to control LED RGB strip lighting changing the brightness and colour with two separate controls.
ideally i would turn the capacitive sensor into a strip, is this possible with a copper strip connected to the sensor or foil?!

unfortunately I am very new to arduino, so basically any suggestions of parts needed? resistors? where to put the right wires etc would be very appreciated, or any projects that have been done before


thanks
liam

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy