Loading...
« previous topic   next topic »
Pages: 1 ... 5 6 [7]   Go Down
Author Topic: Implementation for Microchip ENC28J60 Ethernet controller  (Read 24753 times)
0 Members and 1 Guest are viewing this topic.
konfiot
Offline Offline
Newbie
*
Karma: 0
Posts: 10
View Profile
« Reply #90 on: April 26, 2012, 12:53:55 am »
 Bigger Bigger Smaller Smaller Reset Reset
If you have an Arduino Mega, you have to do a hardware hack to get it work, the link is given in th description of the library
Logged

alvydas001
Offline Offline
Newbie
*
Karma: 0
Posts: 16
View Profile
« Reply #91 on: May 08, 2012, 03:28:52 am »
 Bigger Bigger Smaller Smaller Reset Reset
Quote from: alvarojusten on August 07, 2011, 04:46:43 am
Quote from: mmoz on August 06, 2011, 11:33:45 am
Has anyone experience with this library and the nanode ? (http://wiki.hackspace.org.uk/wiki/Project:Nanode)


Where can I buy a nanode for testing?
Nanode v5 ​​and nanode rf with the library Ethernet_ENC28J60 does not work.
Nanode and Arduino difference:
Pin 8 of the pin used by the microcontroller to select the ENC28J60 for the SPI bus.
Logged

TomasHC
Slovakia
Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
« Reply #92 on: January 16, 2013, 10:33:14 am »
 Bigger Bigger Smaller Smaller Reset Reset
Hello all, any update on this? I'm using your library, with small upgrade as I needed e.print(float).

Additionally, everyone interested in ENC board, this works perfectly, and it's quite cheap + almost free shipping! 3.79€ + 0.50€

http://www.geeetech.com/arduino-enc28j60-ethernet-module-p-263.html
Logged

Pages: 1 ... 5 6 [7]   Go Up
Print
« previous topic   next topic »
 
Jump to: