Go Down

Topic: Implementation for Microchip ENC28J60 Ethernet controller (Read 35 times) previous topic - next topic

GaryP

Finally I got my project started and assembled.
I have communication ok, I can program the MCU.... ethernet circuit is alive, at least it is powered, but I'm not sure if it's really talking with the prosessor. When I open browser and try to connect any IP inside the subnet, this blinks the green light like somebodys knocking, but I can't get response from it.

I have checked this dirty PCB so many times in last two days, that I'm just blind if there's shortcuts or missing links. Schematic has been turned upside down while tracing the problem, components are correct values. Voltages are in tolerances.


WebServerDebug don't give anything.

Hmm, what is the purpose of these dip swithes? I didn't put them for two reason; I don't have suitable and I don't know if it is nessessary in basic testing.

About codes, I only changed the IP-address to much my network, everything else is intact.


It just don't play the game with me, any tips left? Thanks!!!

Cheers,
Kari
The only law for me; Ohms Law: U=R*I       P=U*I
Note to self: "Damn! Why don't you just fix it!!!"

Goes

Tkanks for your reply

So, UDP are fully implemented ? We are able to send & receive packets correctly ?
For TCP, it work too ? You just don't have implemented file server for the access by browser (& GET requests, etc ...) ?

Good luck, it's a good job that will surely help the community


I have see nice, cheap (10$) & small boards with the chip:


Nice for DIY projects ...
8)

++

GaryP

Hmm, I have probably confused with the topic I just posted.

This was the one I built...
http://www.instructables.com/id/A-credit-card-sized-Ethernet-Arduino-compatable-co/

Back to the problem!

Cheers,
Kari
The only law for me; Ohms Law: U=R*I       P=U*I
Note to self: "Damn! Why don't you just fix it!!!"

GaryP

No problem anymore, never was, just wrong libraries. Ethershield...
:smiley-sad-blue:

Cheers,
Kari
The only law for me; Ohms Law: U=R*I       P=U*I
Note to self: "Damn! Why don't you just fix it!!!"

maniacbug


I have see nice, cheap (10$) & small boards with the chip:


Nice for DIY projects ...


Yeah, these look great.  Where have you seen them for $10?!  I've only seen them for $17.

Go Up