Go Down

Topic: how much load can be pulled with my stepper? (Read 472 times) previous topic - next topic


I tried tu pull 5 kg verticaly with a stepper: 15V, 0.4A, 100mNm and a gearhead 2:25.
I calculated: 0.1Nm*12.5*72(gearhead efficiency) / 100 = 0.9 Nm
So, shouln't it be possible to pull 5 Kg with a 1cm wheel?


Be aware that stepper motors are rated by holding torque, not quite the same as pulling torque, but probably close.  Also the torque rapidly drops off with speed.

But the ultimate test is trying it!  If you can use a smaller wheel if necessary then its not too critical - change to a smaller wheel until it can pull the load.
[ I will NOT respond to personal messages, I WILL delete them, use the forum please ]

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131