Pages: 1 [2]   Go Down
Author Topic: Blink example only works when the serial monitor is ON  (Read 1159 times)
0 Members and 1 Guest are viewing this topic.
Manchester (England England)
Offline Offline
Brattain Member
*****
Karma: 602
Posts: 33374
Solder is electric glue
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Thanks.
I notice you have compiled the program as "serial" rather than "arduino-serial" is that right?

Also the code is contridictory at one point it says:-
 printf("Usage: arduino-serial -p <serialport> [OPTIONS]\n"
and later it says:-
"Note: Order is important. Set '-b' before doing '-p'. \n"

You can't have it both ways. Have you tried it the other way round?
Logged

Pages: 1 [2]   Go Up
Jump to: