Go Down

Topic: Daisy chain zigbee and motor controller UART/TTL (Read 1 time) previous topic - next topic


I'm currently looking into using a zigbee module to wirelessly communicate with my arduino uno. It seems that the zigbee module uses the TX and RX serial/digital ports on the arduino. But currently the motorcontroller choice uses those ports as well. Is it possible to daisy chain the two devices? I think the motorcontroller supports some sort of daisy chaining, a pololu protocol (the motorcontroller is by pololu).

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131