Go Down

Topic: 200 m Wire communication  (Read 139 times) previous topic - next topic

Se7S_92

I am looking for the best way to wire communicate between two Arduino boards for 200 m .... I was searching about serial communication protocols "USART, SPI, I2C" and all what i found that i can't reach that distance using them.
I am looking for baud rate about 4800 any thing around that will be good.
thanks in advance.

jremington

#1
Oct 08, 2018, 12:23 am Last Edit: Oct 08, 2018, 12:28 am by jremington
Use standard serial, and on each end use RS422 adapters (for full duplex) or one RS485 adapter (for half duplex), with twisted wire cable.

Good for up to 1000 m at low baud rates.

Se7S_92

thanks a lot, it worked fine using RS422 adapters

Go Up