Go Down

Topic: Arduino ISP Shields (Read 2223 times) previous topic - next topic


Im really starting to get into the modular aspect of the arduino and shields, (after quite a while of not really being that into shields, and to a point resenting the far from standard pin pitch that meant etching your own PCBs rather then using strip board!)

But now I can afford 3rd party shields, and etch my own boards shield have really grown on me as....and i get it now!

Was reading the isp guide http://arduino.cc/en/Tutorial/ArduinoISP and Iv seen the ISP shield that turns your arduino into a standard  6-pin ribbon cable ISP, but was wondering if there were any nice open source single sided one with a dip fitted to the shield for programming of ATmega168/328 chips, or even other smaller tiny chips? 


If you are going to be custom programming some ATmega chips you may want to get the HV Rescue Shield 2 from MightyOhm.com.  It allows you to re-set the fuses on almost any AVR DIP processor (28 pin, 20 pin and 8 pin).  It uses high-voltage parallel programming so it doesn't need the AVR chip to have a valid clock.  Even if serial programming has been accidentally disabled the HVRS2 can reset the chip to factory settings.

An $13 ISP Shield from Evil Mad Science:
It looks like it only supports28-pin ATmega8/168/328 processors.

$3 for the bare board:
Send Bitcoin tips to: 1G2qoGwMRXx8az71DVP1E81jShxtbSh5Hp

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131