Go Down

Topic: accelerometer filtering before board? (Read 692 times) previous topic - next topic


I am just about to set up an accelerometer to an Arduino, but read this on the Sparkfun website;

"You will need some extra hardware to convert this analog signal to a usable digital one."

I searched the forum about this but couldnt find anything. Do I need to do anything else besides just plugging the accelerometer into the analog in pins?


Nope, you don't need anything else if you're using the arduino analog pins for the accelerometer. if you were using the digital input pins, you would have to convert the analog output of the accelerometer to a digital output using something like an ADC chip.


analog pin of arduino has what you need: an internal ADC (analog to digital converter) with 10 bit precision, that's quite good
sei nuovo? non sai da dove partire? leggi qui: http://playground.arduino.cc/Italiano/Newbie


Did you buy the chip? Did you buy the breakout board? Which accelerometer?

Without that information the answers you have received are just guesses based on what people think you have.
Just another Hacker

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131