Pages: [1]   Go Down
Author Topic: stand alone atmega328 pwm pin input??  (Read 662 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

so im making a remote for my camera and on breadboard and arduino everything worked great, but when i put everything on a pref board pin 3 stopped reading my IR input. i believe its all hooked up the same as before when it was plugged into the arduino. does pwm input work septate from the arduino board or is there some resistor or something im missing?????
Logged

Connecticut
Offline Offline
Edison Member
*
Karma: 17
Posts: 1216
RTFD (Datasheet in our case)
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

PWM input?

And have you installed the Arduino bootloader?
Logged

Austin, TX
Offline Offline
Faraday Member
**
Karma: 71
Posts: 6133
Baldengineer
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
when i put everything on a pref board pin 3 stopped reading my IR input

Swap just the ATmega chip.  If your circuit works, you hooked up your perf board correctly.  If it doesn't, you didn't.
Logged

Capacitor Expert By Day, Enginerd by night.  ||  Personal Blog: www.baldengineer.com  || Electronics Tutorials for Beginners:  www.addohms.com

ottawa, canada
Offline Offline
God Member
*****
Karma: 6
Posts: 990
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

There's nothing extra on the analog input pins of the arduino boards.

You probably need to show a picture or schematic. If everything except analog inpuys works on the perf board check particularly that pin and avcc.
Logged

0
Offline Offline
Shannon Member
****
Karma: 200
Posts: 11694
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

PWM pins have to be outputs to generate PWM!  Have you done a full continuity check?
Logged

[ I won't respond to messages, use the forum please ]

Manchester (England England)
Offline Offline
Brattain Member
*****
Karma: 602
Posts: 33374
Solder is electric glue
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
everything worked great, but when i put everything on a pref board pin 3 stopped reading my IR input.

Then you wired it up wrong.

Quote
i believe its all hooked up the same as before when it was plugged into the arduino.

Many people believe many things for which there is no proof. Here there is proof to say what you believed is not true.

Logged

Western New York, USA
Offline Offline
Faraday Member
**
Karma: 32
Posts: 4258
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
... but when i put everything on a pref board ...
What is your definition of 'everything'?

Don
Logged

Pages: [1]   Go Up
Jump to: