Go Down

Topic: Could not find USB device 0x1781/0xc9f (Read 1 time) previous topic - next topic

SFoster

I used to use a TinyISP to burn sketches to an Mega2560 because I didn't have the bootloader. I now have the ability to burn the bootloader and would like to switch back to burning skteches via USB. Any ideas how to do that? I changed the boards.txt file to use the tinyISP but I can't figure out how to change it back. I even deleted arduino022 and replaced it with a fresh install.

Thanks in advance

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy