Loading...
« previous topic   next topic »
Pages: [1]   Go Down
Author Topic: EAGLE  (Read 307 times)
0 Members and 1 Guest are viewing this topic.
baum
Connecticut
Offline Offline
Edison Member
*
Karma: 16
Posts: 1214
RTFD (Datasheet in our case)
View Profile
« on: April 09, 2011, 04:06:45 pm »
 Bigger Bigger Smaller Smaller Reset Reset
I've just been working with EAGLE and I'm trying to design my board. Problem is the part names and values don't show... Any ideas?


Thanks!
Logged
I'm not kidding. If I am asking a question whose answer is found within the concerned product's datasheet, shame on me. If I am answering a similar question, shame on you!

CrossRoads
Global Moderator
Boston area, metrowest
Offline Offline
Brattain Member
*****
Karma: 245
Posts: 16515
Available for Design & Build services
View Profile
WWW
« Reply #1 on: April 09, 2011, 09:00:29 pm »
 Bigger Bigger Smaller Smaller Reset Reset
Under View, check what Layers are being displayed.
Logged
Designing & building electrical circuits for over 25 years. Check out the ATMega1284P based Bobuino and other '328P & '1284P creations & offerings at  www.crossroadsfencing.com/BobuinoRev17

baum
Connecticut
Offline Offline
Edison Member
*
Karma: 16
Posts: 1214
RTFD (Datasheet in our case)
View Profile
« Reply #2 on: April 09, 2011, 09:27:57 pm »
 Bigger Bigger Smaller Smaller Reset Reset
Yep. I just figured this out. Half the layers were turned off, just turned them on. Thanks!
Logged
I'm not kidding. If I am asking a question whose answer is found within the concerned product's datasheet, shame on me. If I am answering a similar question, shame on you!

Pages: [1]   Go Up
Print
« previous topic   next topic »
 
Jump to: