Go Down

Topic: EAGLE (Read 555 times) previous topic - next topic

baum

I've just been working with EAGLE and I'm trying to design my board. Problem is the part names and values don't show... Any ideas?


Thanks!

CrossRoads

Under View, check what Layers are being displayed.
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

baum

Yep. I just figured this out. Half the layers were turned off, just turned them on. Thanks!

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy