Go Down

Topic: Please help (Read 104 times) previous topic - next topic

Norbert17

So,I just got an Arduino Nano and every time I try to upload a progarm it gives me this error:


avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0xa2

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0xa2

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0xa2

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0xa2

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0xa2

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0xa2

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0xa2

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0xa2

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0xa2

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0xa2

avrdude done. Thank you.

On the page where I bought it I read that the board is using the CH340G chipset.I downloaded the driver from that page but I still get the same error.I use Win 7.What should I do ?

sterretje

#1
Nov 21, 2018, 06:40 pm Last Edit: Nov 21, 2018, 06:41 pm by sterretje
Do you have the option 'old boot loader' under tools -> processor?

If so, try that.

If not, you're using an outdated board manager and if your Nano is an original 2018 model, you will need to upgrade to board manager version 1.6.21.

Note that I'm talking about the version of the board manager, not about the version of the IDE.

From memory, you can find the board manager under tools -> boards and update it from there.
If you understand an example, use it.
If you don't understand an example, don't use it.

Electronics engineer by trade, software engineer by profession. Trying to get back into electronics after 15 years absence.

Go Up