Pages: [1]   Go Down
Author Topic: RS422 and Arduino Schema is ok ?  (Read 2046 times)
0 Members and 1 Guest are viewing this topic.
France
Offline Offline
Sr. Member
****
Karma: 2
Posts: 380
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I want to realise a transmission with 2xmax485 for 422 full duplex communication (TX+/TX-/RX+/RX-)

Is this schéma is ok for you. The length of the line will be < 10meters

Is it necessary or better to use optocopler like 4N28 ?

Thanks for your comments.

« Last Edit: April 12, 2011, 08:17:00 am by Grag38 » Logged

Cumming, GA
Offline Offline
Edison Member
*
Karma: 20
Posts: 1658
Ultimate DIY: Arduino
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

It looks fine.  You should not need or want opto-couplers.  You want something designed to overcome the influence of wire length... and these chips do that.
Logged

France
Offline Offline
Sr. Member
****
Karma: 2
Posts: 380
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Thanks for a so speed answer ! I will realize that circuit.

I will tell you you more when my project will be efficient !

Grag38
Logged

Pages: [1]   Go Up
Jump to: