Go Down

Topic: Lithium battery 3.6V 14Ah. (Read 256 times) previous topic - next topic

hysik

Hi!
I need to deploy MKR GSM 1400 module with 2 x FANSO ER34615M/S STD batteries, if you look them they are 3.6V Lithium with 14.000mAh but my question is, where can I solder cables for powering device?
Will be good using battery port and connect all sensors to VCC?
Maybe using USB as battery powering?
Thanks for you help and regards!

ballscrewbob

They are LiOn not LiPo so I would not use the battery port.

You have two other choices which are the USB connector as you figured out and the VIN pin.
Take note of the specs of the VIN pin though before committing to your deployment.


It may not be the answer you were looking for but its the one I am giving based on either experience, educated guess, google or the fact that you gave nothing to go with in the first place so I used my wonky crystal ball.

Go Up