Pages: [1]   Go Down
Author Topic: Getting Rid of the Arduino Board  (Read 1129 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I have a Arduino Uno and want use the Atemga 328p with Arduino code without UNO board.

How do I do?

I have tried to connect it like this. http://arduino.cc/en/Tutorial/ArduinoToBreadboard.
But it is only for Duemilanove.


I programmed my Atmega328P in my UNO Board. Then connect it like this + a led (BLINK). I use Digital pin 13 for led. But nothing happend.

I have no contact between rx and tx to my UNO Card.

Help please.
« Last Edit: April 15, 2011, 10:57:04 am by robbenr » Logged

Massachusetts, USA
Offline Offline
Tesla Member
***
Karma: 178
Posts: 8064
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Did you connect your LED to pin 19 of the ATmega chip?  That's the Arduino D13 pin.

What do you mean by "I have no contact between rx and tx to my UNO Card."?
Logged

Send Bitcoin tips to: 1L3CTDoTgrXNA5WyF77uWqt4gUdye9mezN
Send Litecoin tips to : LVtpaq6JgJAZwvnVq3ftVeHafWkcpmuR1e

Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Yes! I connect LED to pin 19 of the ATmega chip?

I mean that green and yellow wire in the picture, I never connected.
Logged

Massachusetts, USA
Offline Offline
Tesla Member
***
Karma: 178
Posts: 8064
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

OK, so you don't need the USB connection, just power (+5 and Ground).

Some prototype boards have the power and ground busses split in the middle.  If you are feeding the power in on the left it might not get to the wires on the right.  Check that.

Reset (pin 1 of the chip) should connect to +5 through the resistor.

Sometimes a proto board will have a bad connector.  Something might not be connecting.  Wiggle all the connections. smiley
Logged

Send Bitcoin tips to: 1L3CTDoTgrXNA5WyF77uWqt4gUdye9mezN
Send Litecoin tips to : LVtpaq6JgJAZwvnVq3ftVeHafWkcpmuR1e

Portugal
Offline Offline
God Member
*****
Karma: 5
Posts: 962
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Connecting the crystal using wires is a bad thing, the capacitance of the wires can be enought to prevent it from oscilatting.
Logged

nr Bundaberg, Australia
Offline Offline
Tesla Member
***
Karma: 121
Posts: 8430
Scattered showers my arse -- Noah, 2348BC.
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Also the breadboard itself has a high capacitance, I'd plug the crystal directly into the holes near the chip.

There are no decoupling caps either, often on breadboards you can get away without because of the high capacitance, but I'd put a couple of 0.1uF caps right near the power pins of the chip.

______
Rob
Logged

Rob Gray aka the GRAYnomad www.robgray.com

Pages: [1]   Go Up
Jump to: