Go Down

Topic: Arduino Uno not providing power? (Read 1 time) previous topic - next topic


We had one like this months back on the old forum, turns out he was using a 220K ohm resistor instead of 220 ohms...............

If you don't put a resistor on an LED its the output gate of the Atemega chip that is doing the current limiting, an expensive and fragile substitute for something costs next to nothing. 

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131