Pages: [1]   Go Down
Author Topic: Could not find USB device 0x1781/0xc9f  (Read 1519 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I used to use a TinyISP to burn sketches to an Mega2560 because I didn't have the bootloader. I now have the ability to burn the bootloader and would like to switch back to burning skteches via USB. Any ideas how to do that? I changed the boards.txt file to use the tinyISP but I can't figure out how to change it back. I even deleted arduino022 and replaced it with a fresh install.

Thanks in advance
 
Logged

Pages: [1]   Go Up
Jump to: