Pages: 1 [2]   Go Down
Author Topic: simple two position servo  (Read 3656 times)
0 Members and 1 Guest are viewing this topic.
95060
Offline Offline
Newbie
*
Karma: 0
Posts: 26
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

thanks again
I've been very busy with my every day toil and haven't actually tried nested If statements as yet I will pay attention to re-reading IR value. I'm guessing I should read IR just after delay and just before following if IR value test .... I'll post code when I actually mess with it ... life is full of distractions. And rats.
Logged

Pages: 1 [2]   Go Up
Jump to: